Gyro Sensor; Gyro; Jog Key - FUTABA 6K Instruction Manual

Gyro sensor

GYRO

Function
This mixing adjusts the gyro sensitivity from the
transmitter. The AVCS gyro (AVC mode) or normal
gyro (NOR mode) can be selected.
●The gain can be linked to the condition (Cond) or
an arbitrary switch and set.
●When the GY mode was selected, "AVC" or "NOR"
is displayed at the gain setting value.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
（1 second）
Activating the function
Condition
● Select the setting item
with the Jog key.
Gyro setup
■ Activating the function
① Select the "MIX" item
a n d t h e n s e l e c t t h e
"ON" by pressing the +
key or – key.
● When you do not use a function, set to the
"INH" side.
■ Gyro mode and gain setting
③ When choosing Cond. → Set a mode and gain every each condition.
When choosing Switch → UP, CNT, DWN, shows the switch position. Set the respective
positional gain and mode.
AVC 100%
When a ＋ key is
pressed, gain of the
AVCS side is UP.
② Select "GYRO"
from the menu with the

Jog key.

（Gyro type）
● When a Futaba GY gyro is used, gyro type "GY" is selected. This switches the gyro gain setting
item to the mode and gain direct reading display.
■ Gain switch selection
② Select the "SW" item
＋ －
or
GAIN=OFF
0%
AVCS
＋
●The sensitivity setting channel can be selected.
●T6K only 1 channel gain control.
●3 axes gyro of gain can't be controlled
independently.
③ Open the setting screen by
pressing the Jog key.
● When not using this function,
Gain switch selection
（Present switch position）
● Swit c h e s t o t h e
（Gyro Gain set）
and then select the
switch by pressing the
+ key or – key.
Range：Cond, SwA ～ SwD
NOR 100%
Normal
When a － key is
－
pressed, gain of the
Normal side is UP.
(HELICOPTER)
select INH.
g a i n s e t t i n g
s c r e e n o f e a c h
condition when
the Jog key is pressed.
＋ －
or
121