FUTABA 6K Instruction Manual page 116

Throttle Cut
■ Switch selection
③ Select the "SW" item and then select
the switch by pressing the + key or –
key.
＋
Range：SwA ～ SwD
Default：SwA
■ Cut Position rate
⑤ Select the "RATE" item and then select
the cht position by pressing the + key or
– key (motor stop).
＋
● It adjusts to the position where an engine
is cut.
Range：-30 ～ 0 ～ +30%
● When you want to return the set value
to the initial value, press the + key and –
key simultaneously.
NOR MODE（Engine）
THR CHT
OFF
ON
Cut switch ON
Release
OFF
ON
Cut switch OFF
116
－
or
－
or
Default：0%
THR stick Low
(It's possible to do
positional change.）
THR stick Low
THR Active
(It's possible to do
positional change.）
■ Switch direction
④ Select the "POSI" by pressing the + key or – key at
the ON direction selection item.
＋
● 2P SW：NULL, UP, DOWN
● 3P SW：NULL, UP, UP&D, UP&C, CNTR, C&DN,
DOWN
■ Function Throttle Position
⑥ Select the "THR" item and then select the position
by THR stick is lowered and Jog key is pressed for 1
second.
● Set to a safe low throttle position.
THR CHT
OFF
ON
Cut switch ON
Release
Engine
stop
THR stick
middle-high
(Besides the low)
THR stick
Low
(It's possible to do
positional change.）
－
or
Range：
Range：0 ～ 100%
Default：15%
ESC MODE（Motor）
Motor Stop
OFF
ON
Cut switch OFF
OFF
ON
Cut switch
Low→High
OFF
Motor Stop
Start