Throttle Curve - FUTABA 6K Instruction Manual

Throttle curve

THR CRV
Function
This function sets a 5 point throttle curve so that
the engine/motor speed relative to movement of the
throttle stick is the optimum value for flight.
●A curve can be set for each switch position.
However, this function cannot be used when the throttle EXP function was set. When this function is set,
the throttle EXP function cannot be used.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
（1 second）
Activating the function
Switch selection
5 point curve
● Select the setting item
with the Jog key.
Throttle curve
■ Activating the function
① Select the "MIX" item
a n d t h e n s e l e c t t h e
"ON" by pressing the +
key or – key.
● When you do not use a function, set to the
"INH" side.
■ 5 point curve set
③ By Jog key, either of P-1 to P-5 is chosen. The + key or - key is pressed and a
rate is set up.
Default：P-1 : 0%, P-2 : 25%, P-3 : 50%, P-4 : 75%, P-5 : 100%
WING TYPE
② Select
from the menu with the
Jog key.
set
＋ －
or
Range：0 ～ 100%
1AIL 1AIL1FLP
"THR CRV"
③ Open the setting screen by
■ Switch selection
② Select the "SW" item
and then select the
switch by pressing the
+ key or – key.
Range：SwA ～ SwD Default：SwC
(AIRPLANE)
2AIL 2AIL1FLP ELEVON
pressing the Jog key.
● When not using this function,
select INH.
● The set-up curve is shown
（Present switch position）
＋ －
or
＋ －
or
101