Gyro Sensor - FUTABA 6K Instruction Manual

Gyro sensor

GYRO
Function
This function is dedicated mixing for switching
the gyro sensitivity and gyro mode (AVCS/
NORMAL) of Futaba airplane use gyros.
●This gyro function isn't used for a flight. A flight gyro
is equipped already in a multicopter. (e.g, the
angle keep of the camera, it's used.)
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
（1 second）
Each switch position
Gyro type / Gain rate
● Select the setting item
with the Jog key.
GYRO setup
■ Activating the function
① Select the "MIX" item
a n d t h e n s e l e c t t h e
"ON" by pressing the +
key or – key.
● When you do not use a function, set to the
"INH" side.
■ Gyro mode and gain setting
③ UP, CNT, DWN, shows the switch position. Set the respective positional gain and mode.
AVC 100%
When a ＋ key is
pressed, gain of the
AVCS side is UP.
② Select
"GYRO"
from the menu with the
Jog key.
（Gyro type）
■ Gain switch selection
② Select the "SW" item and then select the
＋ －
or
GAIN=OFF
0%
AVCS
＋
③ Open the setting screen by
pressing the Jog key.
● When not using this function,
select INH.
Gain switch selection
（C u r r e n t s w i t c h o p e r a t i n g
direction）
● Switches to the gain
s e t t i n g s c r e e n o f
each switch direction
（Gyro Gain） when the Jog key is
pressed.
switch by pressing the + key or – key.
＋
or
Range：SwA ～ SwD Default：SwB
NOR 100%
Normal
When a － key is
－
pressed, gain of the
Normal side is UP.
(MULTICOPT)
－
157