Toshiba e-STUDIO170F Service Manual page 457

[ 2 ] Device error codes
Device error code indicates the cause of a device error by a 2-digit number.
Error Code
22 to 24 The fuser failed to operate normally.
41 The polygon motor in the LSU failed to operate.
42 The laser beam was not controlled correctly.
43 The HVPS failed to operate normally.
51 The FAN motor failed to operate normally.
60 Communication error between the main-CPU
(IC22) and the engine-CPU (IC37).
80 The DSC (IC59) failed to operate normally.
81 The RTC (IC23) failed to operate normally.
82 The MODEM (IC5) for Line-1 failed to operate
normally.
[ 3 ] Paper jam error codes
Paper jam error codes indicate where (within the machine) a recording paper jam has occurred using a
2-digit number.
Error Code
10 A paper jam has occurred within the paper feed
section of the recording paper tray.
20 A paper jam has occurred within the paper feed
section of the optional recording paper tray.
80 A paper jam has occurred within the drum/devel-
oper section of the paper transport path.
90 A paper jam has occurred within the paper exit
section of the paper transport path.
January 2005 © TOSHIBA TEC
Cause
Cause
11 - 45
Remedy
Refer to P.11-52 "[ 7 ] DEVICE ERROR
22 to 24".
Refer to P.11-53 "[ 8 ] DEVICE ERROR
41 and 42".
Refer to P.11-53 "[ 8 ] DEVICE ERROR
41 and 42".
Replace the HVPS.
Refer to P.11-53 "[ 9 ] DEVICE ERROR
51".
Replace the main PBA.
Replace the main PBA.
Replace the main PBA.
Replace the main PBA.
Remedy
Draw out the recording paper tray (Upper)
and remove any jammed recording paper.
If the same error code is displayed again,
refer to P.11-55 "11.4.5 Recording
paper feed error".
Draw out the recording paper tray (Lower)
and remove any jammed recording paper.
If the same error code is displayed again,
refer to P.11-55 "11.4.5 Recording
paper feed error".
Open the front cover, remove the toner
cartridge and drum unit, and remove any
jammed recording paper.
If the same error code is displayed again,
refer to P.11-55 "11.4.5 Recording
paper feed error".
Open the RX cover, remove the toner car-
tridge and drum unit, and remove any
jammed recording paper.
If the same error code is displayed again,
refer to P.11-55 "11.4.5 Recording
paper feed error".
e-STUDIO170F Troubleshooting
11