Toshiba e-STUDIO170F Service Manual page 209

[ 1 ] Temperature Control
Warm-up
205 °C
185 °C
160 °C
130 °C
[ 2 ] Temperature Control Adjustment Mode
The temperature of the heat roller is adjusted by the following modes according to the time frame from
"During printing" and "Warm-up completed".
Mode 1:
For 300 seconds (even though mode 1 is stopped in the middle of adjusting, the count of timer
before stopping is continued if the temperature of the heat roller is 50°C or more.) When mode 1 is
finished, mode 2 is started.
Mode 2:
For 208 seconds. The temperature of the heat roller is gradually lowered. When it reaches the one
in mode 3, mode 2 is finished and mode 3 is started.
Mode 3:
Adjusting the temperature is continued until it is restarted by turning the power ON again, opening/
closing the front cover and releasing the pause mode.
[ 3 ] Heat Roller Temperature In Each Temperature Adjustment Mode
Plain paper
Thick paper, Envelope, Post card
OHP film
January 2005 © TOSHIBA TEC
Thermistor detecting temperature
Mode 1 Mode 2
( 300 sec. ) ( 208 sec. )
Fig.5-14
Mode 1
205ºC
195ºC
5 - 17
Printing ( 600 dpi )
Waiting
Mode 3
Mode 2 Mode 3
205ºC 185ºC 185ºC
205ºC 215ºC
195ºC 185ºC 185ºC
e-STUDIO170F Mechanical Description
5