Toshiba e-STUDIO170F Service Manual page 417

[ 2 ] KEY TEST [MENU], [9], [2], [02]
This test checks the key switch operation on the Operation panel.
1) Use the [ ] or [ ] key to select "02. KEY TEST", and then press the [ENTER] key.
KEY TEST
PRESS [STOP] LAST
2) Press all the keys except the [STOP] key. At this time, the status of each key pressed is shown at
the lower right on the screen.
KEY TEST
Remark:
The statuses of the keys shown when pressed are listed in the table below.
Key Status Table
Key name
[0] to [9], [#], [*]
[MULTI/CHANGE CODE]
[SPEED DIAL/ALPHA]
[REDIAL/PAUSE]
[MONITOR]
[START]
[STOP]
[COPY]
[MODE]
[CONTRAST]
[INSERT]
[DELETE]
[JOB STATUS]
[SUPER ENERGY SAVER]
When all the keys except the [STOP] key are pressed, the display will show the following screen.
KEY TEST
PRESS [STOP]
Remark:
If no key has been pressed and a period of 10 seconds has elapsed, the test result will be "NG".
January 2005 © TOSHIBA TEC
SHIFT Pressing key status (When [SHIFT] key pressed)
Display
TK0 to TK9, #, * [ /MENU]
MULTI [ ]
ABB [ ]
PAUSE [ ]
MONITOR [JOB CANCEL]
START [ENTER]
STOP [DIRECT SEND]
COPY [TX REPORT]
MODE [CHAIN DIAL]
CONTRAST [JOURNAL]
INSERT [AUTO]
DELETE One touch keys
JOB STATUS [SHIFT]
POWER SAVE
11 - 5
Key name
UP/MENU
LEFT/BACK
RIGHT
DOWN
CANCEL
ENTER
A
P
C
M
R
OT01 to OT19
SHIFT
e-STUDIO170F Troubleshooting
Display
11