8.2.3
Top Block
[ 1 ] TX Drive Assembly
Before disassembling or reassembling, be sure to refer to
sembling".
(1)
Remove the operation panel assembly. (Refer to
(2)
Remove the right side cover. (Refer to
(3)
Remove the left side cover. (Refer to
(4)
Remove the five screws from the main PBA cover, and remove the FG cable and main PBA
cover.
Note:
A speaker and a battery are installed inside of the main PBA cover. Each harness of this speaker
and this battery is connected to the main PBA. Therefore do not pull the main PBA cover
strongly.
January 2005 © TOSHIBA TEC
P.8-1 "8.1 Before Disassembling or Reas-
P.8-3 "[ 1 ] Operation Panel Assembly")
P.8-5 "[ 2 ] Right Side Cover")
P.8-6 "[ 3 ] Left Side Cover")
Screw
FG cable
Screw
Fig.8-18
e-STUDIO170F Removal/Replacement/Adjustment
8 - 15
Screw
Main PBA cover
8