Toshiba e-STUDIO170F Service Manual page 422

[ 6 ] SENSOR TEST [MENU], [9], [2], [06]
This test checks if the detection sensors operate normally.
The test items in SENSOR TEST mode are as follows:
• Detection of top cover open/closed status
• Detection of Recording paper presence/absence status
Remark:
If no operation is performed within 40 seconds after an operational instruction is displayed on the
screen in the switch test, the test result will be judged to be NG.
1) Use the [ ] or [ ] key to select "06. SENSOR TEST", and then press the [ENTER] key.
SENSOR TEST
OPEN TOP COVER
2) Open the top cover. When its open state is detected, the screen below appears. After checking that
the screen is displayed, close the top cover.
Detects the open state
of the top cover
SENSOR TEST
CLOSE TOP COVER
3) Open the front cover. When its open state is detected, the screen below appears. After checking that
the screen is displayed, close the front cover.
Detects the open state
of the front cover
SENSOR TEST
CLOSE FRONT COVER
4) Take out the recording paper from the Recording paper tray. When the absence of recording paper
is detected, the screen below appears. After checking that the screen is displayed, place the record-
ing paper in the Recording paper tray.
Detects the absence
of Recording paper
SENSOR TEST
PUT IN PAPER
e-STUDIO170F Troubleshooting
Close the top cover
SENSOR TEST
OPEN FRONT COVER
Close the front cover
SENSOR TEST
REMOVE PAPER
11 - 10
January 2005 © TOSHIBA TEC