Flash On Time - Datalogic Gryphon I GD44XX Product Reference Manual

References

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in
100 millisecond increments.
Follow these instructions to set this feature.
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad
3. Go to
4. Scan the bar code: SELECT FLASH ON TIME SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure. See
feature.
Table 41. Flash On Time Setting Examples
STEP ACTION
1 Desired Setting
Divide by 100 (and pad with
2 leading zeroes to yield two
digits)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT FLASH ON TIME SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
298
the result with leading zeroes to yield two digits. For example: 0 = 00,
5 = 05, 20 = 20, etc.
page 114 and scan the ENTER/EXIT PROGRAMMING MODE bar
code to enter Programming Mode.
representing the duration which was determined in the steps above.
You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
ming Mode.
EXAMPLES
500ms
05
'0' and '5'
Table 41 for examples of how to set this
5200ms (5.2
1,000ms (1 sec.)
sec.)
10 52
'1' and '0' '5' and '2'
Gryphon™ I GD44XX/GBT4400/GM440X
Appendix D, Keypad
9,900ms (9.9 sec.)
99
'9' and '9'