Reading Parameters; Good Read Led Duration - Datalogic Gryphon I GD44XX Product Reference Manual

Reading Parameters

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains
on following a good read. The good read LED on time can be set within a
range of 10 milliseconds to 2,550 milliseconds (0.001 to 2.55 seconds) in
100ms increments.
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds. A setting of 0 means that
2. Divide the desired setting by 10 (setting is in 100ms increments). Pad
3. Go to
4. Scan the bar code: SELECT GOOD READ LED DURATION SETTING.
5. Scan the appropriate three digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure. See
set this feature.
Table 37. Good Read LED Duration Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with
2
leading zeroes)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT GOOD READ LED DURATION SETTING
Scan Three Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
the good read LED stays on until the next time the trigger is pulled.
the result with leading zeroes to yield three digits. For example: 0 =
000, 5 = 000, 20 = 020, etc.
page 108 and scan the ENTER/EXIT PROGRAMMING MODE bar
code to enter Programming Mode.
pad representing the duration which was determined in the steps
above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
ming Mode.
EXAMPLES
Good Read LED
stays on until
next trigger pull
(00)
000
'0', '0' and '0'
Table 37 for some examples of how to
20ms 150ms
002 015
'0', '0' and '2' '0', '1' and '5'
Reading Parameters
Appendix D, Key-
2550ms (2.55 sec.)
255
'2', '5' and '5'
293