Datalogic Gryphon I GD44XX Product Reference Manual page 278

References
ACK NAK Timeout Value
This option specifies the amount of time the reader waits for an ACK charac-
ter from the host following label transmission. The selectable timeout range
is 200 milliseconds to 15,000ms (15 seconds) in 200ms increments. A
selection of 0 disables the timeout.
To set this value:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 200 (setting is in 200ms increments). Pad
3. Go to
4. Scan the bar code: SELECT ACK NAK TIMEOUT VALUE SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure. See
set this feature.
Table 28. ACK NAK Timeout Value Setting Examples
STEP ACTION
1 Desired Setting
2 Divide by 200
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT ACK NAK TIMEOUT VALUE SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
276
the result with leading zeroes to yield two digits. For example: 0 = 00,
5 = 05, 20 = 20, etc.
page 53 and scan the ENTER/EXIT PROGRAMMING MODE bar code
to enter Programming Mode.
pad, that represent the duration which was determined in the steps
above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
ming Mode.
EXAMPLES
200ms
01
'0' and '1'
Table 28 for some examples of how to
5200ms (5.2
1,000ms (1 sec.)
sec.)
05 26
'0' and '5' '2' and '6'
Gryphon™ I GD44XX/GBT4400/GM440X
Appendix D, Key-
15,000ms (15 sec.)
75
'7' and '5'