Wedge Quiet Interval; Intercode Delay - Datalogic Gryphon I GD44XX Product Reference Manual

Enter/Exit Programming Mode

Wedge Quiet Interval

Specifies amount of time to look for keyboard activity before scanner breaks
keyboard connection in order to transmit data to host. The selectable range
for this setting is 00 to 990 milliseconds (00-0x63 by 01) in increments of
ten milliseconds. See
examples for setting this feature.
$CKBQI
Set Wedge Quiet Interval
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface.
The selectable range for this feature is from 0 to 99 seconds.
See
ting this feature.
$CKBID
Set Intercode Delay
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
72
page 280
0A = Quiet Interval is
DEFAULT
100 milliseconds
page 282 in "References" for detailed information and examples for set-
00 = No Wedge Intercode Delay
DEFAULT
in "References" for detailed information and
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the
bar code at left followed by the digits from the
Alphanumeric characters in
pad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
~
CANCEL
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the
bar code at left followed by the digits from the
Alphanumeric characters in
pad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
~
CANCEL
Gryphon™ I GD44XX/GBT4400/GM440X
Appendix D, Key-
Appendix D, Key-