Bt Security Features; Bt Security Mode - Datalogic Gryphon I GD44XX Product Reference Manual

On the BT system, it is possible to set a (configurable) PIN code to authenti-
cate/connect BT devices, and encrypt the data.
The BT PIN code can be enabled and configured by reading the bar codes in
the following sections.
Follow these steps to set the PIN code for a scanner:
1.
2.
3. Scan the relevant bar code from
See page 304
for this feature.

BT Security Mode

This feature enables/disables authentication and encryption of the BT link.
Use the feature
in the PIN code used to authenticate the BT Link.
DEFAULT
$CBTSE01(CR)
BT Security Mode = Enable
Product Reference Guide

BT SECURITY FEATURES

If you are using a BT scanner directly connected to a host through a BT
dongle, verify that the scanner and the BT driver used by the dongle share
the same PIN code and the same security level. Otherwise the connection
cannot be established.
Enable BT Security Mode by scanning the "Enable" bar code below.
Select a PIN code length of either 4 or 16 characters by scanning the
appropriate bar code in
the desired alphanumeric characters from the keypad in
Keypad to set the PIN code.
in "References" for more detailed information and examples
"BT PIN Code"
Changing the security mode setting will unlink the devices. If the Automatic
Configuration Update is set to the default "Enabled" setting, the devices must
only be relinked. If the Automatic Configuration Update is set to "Disabled,"
the Security Mode setting must also be updated in the Base Station using
Aladdin. After the Base Station has been updated, the devices must be
relinked.
Enter/Exit Programming Mode
"Select PIN Code Length"
"Set PIN Code"
on page 260 to specify the length and digits
$CBTSE00(CR)
BT Security Mode = Disable
on page 260.
on page 260, then scan
Appendix D,
259