Enter/Exit Programming Mode
Aiming Pointer
Enables/disables the aiming pointer for all symbologies.
$CTAAP01(CR)
Aiming Pointer = Enable
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a
label, when in trigger single mode.The range for this setting is from 1 to
255 seconds in 1-second increments. See
description of this feature.
DEFAULT
LSTM
Set Aiming Duration Timer
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
116
$CTAAP00(CR)
Aiming Pointer = Disable
DEFAULT
page 297
LSTM00
Aiming Off After Decoding
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters
Appendix D, Keypad
in
character(s). End by scanning the ENTER/EXIT bar
code.
~
CANCEL
Gryphon™ I GD44XX/GBT4400/GM440X
in "References" for a
representing your desired