Datalogic Gryphon I GD44XX Product Reference Manual page 292

References
Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Go to
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER
3. Scan a bar code to select the symbology for which you wish to config-
4. Determine the desired character(s) (you may choose up to three) which
5. Turn to the
6. Scan the ENTER/EXIT bar code to exit Label ID entry.
7. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 18. Label ID Position Options
290
page 93 and scan the ENTER/EXIT bar code.
(Enable as suffix) by scanning the appropriate bar code in the section
"Label ID Control" on page 93. Reference Figure 18 for Label ID posi-
tioning options if multiple identification features are enabled.
ure a custom Label ID from the section
1D Symbologies" on page 94.
will represent the Label ID for the selected symbology.
ASCII Chart
the equivalent hex digits associated with your choice of Label ID. For
example, if you wish to select an equal sign (=) as a Label ID, the chart
indicates its associated hex characters as 3D. Turn to
on page 335 and scan the bar codes representing the hex characters
determined. For the example given, the characters '3' and 'D' would be
scanned. More examples of Label ID settings are provided in
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
Prefix Label ID
"Label ID Symbology Selection −
on the inside back cover of this manual and find
Aim ID Bar Code Data
OR
Gryphon™ I GD44XX/GBT4400/GM440X
Keypad, starting
Table 36.
Label ID Suffix