Intercharacter Delay; Beep On Ascii Bel - Datalogic Gryphon I GD44XX Product Reference Manual

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one
character and the beginning of the next. The delay can be set within a range
of zero (0) to 990 milliseconds in 10ms increments. A setting of zero speci-
fies no delay.
See
$CR2IC
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-

Beep On ASCII BEL

When this parameter is enabled, the reader issues a beep when a <BEL>
character is detected on the RS-232 serial line. <BEL> is issued to gain a
user's attention to an illegal entry or other important event.
$CR2BB00(CR)
Beep On ASCII BEL = Disable
Product Reference Guide
page 281 for more information.
ning.
00 = No Intercharacter Delay
DEFAULT
Enter/Exit Programming Mode
$CR2IC00(CR)
Intercharacter Delay = No Delay
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
Appendix D, Keypad
characters in
your desired character(s). End by scanning the
ENTER/EXIT bar code again.
~
CANCEL
DEFAULT
$CR2BB01(CR)
Beep On ASCII BEL = Enable
representing
49