Ack Nak Timeout Value; Ack Nak Retry Count - Datalogic Gryphon I GD44XX Product Reference Manual

ACK NAK Timeout Value

This option specifies the amount of time the reader waits for an ACK char-
acter from the host following label transmission. The selectable timeout
range is 200 milliseconds to 15,000ms (15 seconds) in 200ms increments.
A selection of 0 disables the timeout.
See page 276
$CR2AT
Select ACK NAK Timeout Value Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
DEFAULT

ACK NAK Retry Count

This feature specifies the number of times the reader retries a label trans-
mission due to a retry condition. The selectable range is from 1 to 254
retries. A selection of 0 disables the count, and a selection of 255 specifies
unlimited retries. See
$CR2AR
Select ACK NAK Retry Count Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Product Reference Guide
for more information on setting this feature.
01 ACK NAK Timeout value is 200ms
page 277
003 = 3 Retries
DEFAULT
Enter/Exit Programming Mode
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
Appendix D, Keypad
characters in
your desired character(s). End by scanning the
ENTER/EXIT bar code again.
~
CANCEL
for more information.
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
Appendix D, Keypad
meric characters in
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
~
CANCEL
representing
repre-
53