Micro Pdf417 Length Control; Micro Pdf417 Set Length 1 - Datalogic Gryphon I GD44XX Product Reference Manual

Enter/Exit Programming Mode

Micro PDF417 Length Control

This feature specifies either variable length decoding or fixed length decod-
ing for this symbology.
Variable Length:
length may be set.
Fixed Length:
DEFAULT
$CMILC01(CR)
Micro PDF417 Length Control = Fixed Length

Micro PDF417 Set Length 1

Specifies one of the bar code lengths for
Length 1 is the minimum label length if in
fixed length if in Fixed Length Mode. Length includes the bar code's data
characters only. Characters can be set from 0001 to 0366 characters (pad
with zeroes) in increments of 01. Any value greater than 0366 will be con-
sidered to be 0366.
See
$CMIL1
Select Micro PDF417 Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
234
For variable length decoding, a minimum and maximum
For fixed length decoding, two different lengths may be set.
page 283 for detailed instructions on setting this feature.
0001 = Length 1 is 1 Character
DEFAULT
$CMILC00(CR)
Micro PDF417 Length Control = Variable Length
Micro PDF417 Length
Variable Length
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
Appendix D, Keypad
characters in
your desired character(s). End by scanning the
ENTER/EXIT bar code again.
~
CANCEL
Gryphon™ I GD44XX/GBT4400/GM440X
Micro PDF417
Control.
Mode, or the first
representing