Oce Arizona 250 GT User Manual page 51

7) Job information and parameters panel
The job information area displays job parameters of the current print job. Some of
the parameters may be modified.
[19]
Offsets
Print Parameters
Job Parameters
Notes
8) Printer Module Tabs
These tabs allow you to switch between different functional modules of the printer.
Click on a tab to display the screen associated with each of the modules available.
9) Image Upload Progress
The image upload progress panel indicates the name of a job that is currently
uploading to the printer. This panel only displays information when an image is
uploading from the ProductionHouse computer.
A job's vertical and horizontal offset parameters can be
changed with the mouse wheel when mouse cursor is posi-
tioned over the field. Rotating the mouse wheel up or down
increments or decrements offset at the rate of one unit per
notch. Holding right mouse button and rotating the wheel
increments or decrements at the rate of 10 units per notch.
Displays information about the print job that is currently
selected:
Print quality mode - Production, Quality or Fine Art
mode
Direction - Bidirectional or Forward or Reverse unidi-
rectional printing
Overprints
Copies
Print Method - Flatbed or Roll-to-Roll
ProductionHouse Media used
Notes - Appears only if a note was specified for the job.
Notes are entered in ONYX ProductionHouse.
Copies - use the mouse to increase or decrease, as re-
quired
Type - currently only Flatbed type is available.
Media used - displays the type of media.
Appears only if a note was specified for the job. Notes are
entered in ONYX ProductionHouse.
Print Job Control Module
51