Oce Arizona 250 GT User Manual page 102

Printhead Maintenance
Illustration
[49]
[49] Maintenance Station Switches
How To Perform Maintenance
Slide the cover out from under the carriage to reveal the maintenance station.
1.
Press and release switch 1 to initiate a purge. The carriage will lower to its purge
2.
height (4mm above the table surface). Watch the ink as it falls from the heads. After
a few seconds most of the ink stops dripping and you can then raise the carriage.
Press switch 2 to raise the carriage to its maximum height.
3.
Press switch 3 to turn on the suction pump. Pick up the suction-head from the tray at
4.
the left end of the maintenance station. Wipe the suction-head with a new, clean
lint-free wipe to remove any particles that could damage the nozzles in the
printheads.
[50]
[50] Clean Suction-Head
102 Chapter 8 Printer Maintenance