Servo Amplifier Terminal Block (Te2) Wiring Method; For The Servo Amplifier Produced Later Than Jan. 2006 - Mitsubishi Electric MELSERVO MR-J2S- A Instruction Manual

3. SIGNALS AND WIRING

3.11 Servo amplifier terminal block (TE2) wiring method

3.11.1 For the servo amplifier produced later than Jan. 2006

(1) Termination of the cables
(a) Solid wire
After the sheath has been stripped, the cable can be used as it is.
(b) Twisted wire:
1)When the wire is inserted directly
Use the cable after stripping the sheath and twisting the core. At this time, take care to
avoid a short caused by the loose wires of the core and the adjacent pole. Do not solder the
core as it may cause a contact fault. Alternatively, a bar terminal may be used to put the
wires together.
2) When the wires are put together
Using a bar terminal.
Cable Size
[mm
1.25/1.5
2/2.5
Cut the wire running out of bar terminal to less than 0.5mm.
When using a bar terminal for two wires, insert the wires in the direction where the
insulation sleeve does not interfere with the next pole and pressure them.
POINT
Refer to Table 13.1 (2) and (4) in Section 13.2.1 for the wire sizes used for
wiring.
2
] AWG For 1 cable
16 AI1.5-10BK
14 AI2.5-10BU
Sheath
Core
Approx. 10mm
Bar Terminal Type
For 2 cables
AI-TWIN×1.5-10BK
Less than 0.5mm
Pressure
Pressure
3 - 58
Crimping Tool
CRIMPFOX ZA 3 Phoenix Contact
Maker