Plc Side Setting (Gx Works3); Servo Amplifier Setting (Mr Configurator2) - Mitsubishi Electric MELSERVO-J5 Series Sample Screen Manual

4. PLC SIDE SETTING (GX Works3)

The following shows the default settings in the sample screens.
When using the sample screen, change the setting in accordance with your system configuration.
(1) Select [Parameter] - [R○○CPU] - [Module Parameter].
Then, set the IP address in [Own Node Settings] in [Basic Settings].
Parameter Setting Method
IP Address
(2) Perform the setting of Ethernet Configuration in [External Device Configuration].
Select MELSOFT Connection Module in [Ethernet Device (General)] of [Module List] and add to Ethernet
Configuration.
(3) Select [Parameter] - [Module Information] and add the motion module.
Go to [Required Settings] - [Station Type] and set Station type and IP address.
Station Type
1st PLC Network No.
IP address
Station Type
2nd PLC Network No.
IP address
Station Type
3rd PLC Network No.
IP address
(4) Go to [Basic Settings] - [Network Configuration Settings] to perform the network configuration settings.
For details, refer to the user's manual of the used equipment.

5. SERVO AMPLIFIER SETTING (MR Configurator2)

Check the parameters with MR Configurator2.
If the following settings are not configured, parameters are not read from and written to the servo amplifier in the
sample screens.
Servo parameter writing prohibited *1
IP address setting
IP address
*1: To reflect the set value, cycle the power supply of the servo amplifier.
*2: Configure the setting in accordance with your system configuration.
Item
IP Address
Item
Item
Set Value
Parameter Editor
192.168.10.39
Set Value
Master Station
1
192.168.3.253
Master Station
2
192.168.4.253
Master Station
3
192.168.5.253
Parameter Set Value
PA19
00AB
NPA01
*2
NPA02
23/128
Remarks
-
-
Remarks
-
-
-
-
-
-
-
-
-
Remarks
All parameters can be read and
written.
-
-
BCN-P5999-1471-3c