Mitsubishi LANCER Owner's Manual page 186

Stopping the engine
1. Bring the vehicle to a complete stop.
2. Fully engage the parking brake while depressing the brake
pedal.
3. For vehicles with a manual transaxle, turn the ignition
switch to the "LOCK" position to stop the engine, and
then move the gearshift lever to the 1st (on a uphill) or
"R" (Reverse) (on a downhill) position.
For vehicles with continuously variable transmission
(CVT) or Twin Clutch SST, place the selector lever (CVT)
or the gearshift lever (Twin Clutch SST) in the "P"
(PARK) position, and then turn the ignition switch to the
"LOCK" position to stop the engine.
NOTE
For vehicles with Twin Clutch SST, the engine will stop
N00542300088
and the vehicle power will turn off approximately 1 sec-
ond after the ignition switch is turned to the "LOCK";
position.
The reason for this is that, in the time from when the igni-
tion switch is turned to the "LOCK" position until the
engine stops, the gears inside the Twin Clutch SST disen-
gage so that the engine will start smoothly the next time it
is started.
Two clutches installed in the Twin Clutch SST alternately
engage and disengage to achieve smooth shifting.
In addition, the gear on the side with the free clutch is
engaged, therefore, quick shifting is performed.
If the engine was stopped with the gear engaged like this,
it would provide resistance the next time the engine is
started. Therefore, the gear disengages in the approxi-
mately 1-second period until the engine stops.
For vehicles with Twin Clutch SST, do not operate the
gearshift lever or the accelerator pedal for approximately
1 second until the engine stops.
Features and controls
3
3-91