Mitsubishi LANCER Owner's Manual page 131

Features and controls
To turn from "ACC" to "LOCK"
1. [For vehicles with manual transaxle]
Push the emergency key in at the "ACC" position and
keep it depressed until it is turned to the "LOCK" posi-
tion, and remove.
[For vehicles with continuously variable transmission
(CVT) or Twin Clutch SST]
First, set the selector lever (CVT) or the gearshift lever
(Twin Clutch SST) to the "P" (PARK) position, and then
slowly turn the ignition switch to the "LOCK" position
while pressing it.
3
NOTE
For vehicles with CVT or Twin Clutch SST, the emer-
gency key cannot be removed unless the selector lever
(CVT) or the gearshift lever (Twin Clutch SST) is set to
the "P" (PARK) position.
3-36
2. Install the cover of the ignition switch.
3. Reinsert the emergency key into the F.A.S.T.-key.
NOTE
Always install the cover of the ignition switch when not
using the emergency key. Not doing so could cause dam-
age if foreign material such as dust gets into the keyhole
of the ignition switch.
CAUTION
!
Do not turn the ignition switch to the LOCK posi-
tion while the vehicle is moving. This will cause the
steering wheel to lock, making it impossible to oper-
ate the vehicle.
If the engine is stopped while driving, the power
brake booster will stop functioning and greater
effort for braking will be required. Also, the power
steering system will not function and it will require
greater effort to manually steer the vehicle.
Do not leave the ignition switch in the "ON" position
for a long time when the engine is not running. The
battery will run down.
Do not turn the ignition switch to the "START"
position when the engine is running. It will damage
the starter motor.