Rep5.5Carriage - Xerox Document Workcenter 150 Service Manual

REP 5.5 Carriage &,
Part List on PL 5.1
Removal
CAUTION
Leaving the Ink Cartridge removed for long
periods of time wilt cause the ink nozzles to
dry out. Image quality problems or a blank
print could result. If necessary prime the Ink
Cartridge after minstallation.
1. Disconnect the Power Cord from the outlet.
2. Remove the following:
a. Ink Cartridge Cover (PL 3.1).
b. Ink Cartridge.
c. Rear Cover (REP 1.2).
d. Printer and Tray Assembly (REP 3.1).
e. Printer Assembly (REP 3.2).
f. Carriage Assembly (REP 3.5).
g. Encoder Assembly (REP 5.4).
3. Remove the Carriage (Figure 1).
a.
b.
c.
d.
Open the cable clamps.
Remove the Carriage Shaft Ground
Plates from both sides.
Remove the E-ring.
Remove the screw and the Right Gap
Adjust Plate.
Move the Carriage Shaft to the right to
release the Carriage from the Carriage
Frame.
Remove the Micro Gap Adjusters (Z),
Gap Adjust Lever, and Gap Set Bushing.
Micro Gap
Adjuster
1 Bushing
Ground
Plate
riage
Gap Adjust
Plate
Figure 1
Removing and Replacing the Carriage
Remove the Carriage from the Shaft,
,
REP 5.5 Carriage
5196
4-26
Document WorkCenter 150