Service Mode - Xerox Document Workcenter 150 Service Manual

Table 1 Service Mode Menus
L
i
FUNCTION
1. Monitoring
!. All Backup Cleai
I
All
3. S/w Switch
8. Test Mode 1. Test Tone Transmission] 1. Press Start to listen to each tone generated by thl
i. CIS Tuning
3. Printer
MENU
1. Error Line Monitor
2. Communication
Sequence Code
DESCRtPTlON
1, Monitors and displays the number of error lines
during a transmission. Backup all clear to release
2. Monitors the sequence of a communication in
operation. See the Sequence Code table in this
section.
Note: Cyc/e power to exit monitor mode.
1. S.W. Switch lnitializatiol
2. SrW Switch Value
Change
Clears the machine ID, One-touch and speed dia
numbers, DRAM and all report data. The softwart
table and printer parameters are set to default
values.
1. Resets the soft switch settings to the default
values
2. Allows the fax and printer parameters to be
changed. See Soft Switch Setup procedure in thi:
section.
machine.
2. TPH Pattern Printing 2. Prints the test pattern to check the thermal sensing
record head.
3. RAM Data Printing 3. Prints the stored data.
1. White Level Adjust 1. Checks the white reference level for the output
video signal of the CIS.
2. Dither Level Adjust 2. Adjusts the reference contrast level for the dither
pattern.
3. Contrast Level Adjust 3. Adjusts the reference level for general contrast.
1. Font Print 1. Prints the available fonts.
2. Test Pattern 2. Prints the character set in each font; both portrait
3. Test for Service
1. Print Setup
5. Hex Dump
5. Grid Adjust
7. Select Ink Save
3. Loading Adjust
3. Checker Board Print
and landscape.
3. Runs a conlinuous burn in test. Disconnect powel
to exit.
4. Modifies the printer setup configuration.
5. Clears the Hex registers.
' 6. Adjusts the horizontal print alignment.
7. Selects the ink save mode.
8. Adjusts the top page margin.
9. Enables the checker board print.
Document WorkCenter 150
3/98
s-s
Service Mode