Rep 3.3 Scanner And Guide Assembly - Xerox Document Workcenter 150 Service Manual

REP 3.3 Scanner and Guide Assembly k,
Parts List on PL 3.1
Removal
WARNING
Dlsconnecl the
Power Cord from the
outlet.
1.
Remove the following:
a. Front Cover (REP 1.1).
b.
c.
t; d.
Rear Cover (REP 1.2).
Control Panel Assembly (REP 2.1).
Document Exit Guide (REP 2.2).
Prinler and Tray Assembly (REP 3.1).
2. Remove the Scanner and Guide Assembly
from the Bollom Pan (Figure 1).
a. Disconnect conneclors CN2. CNll,
CN14, and CN15.
b.
Remove the two (2) ground cable scrws.
c. Remove the two (2) mounting screws.
d. Lilt the Scanner and Guide Assembly.
Replacement
1. Ensure that the Scanner Motor harness is
dressed away
from Ihe Scanner gears.
2.
Reinslall the components in the rewse order.
Figure 1 Removing Ihe Scanner and Guide Assembly
Document WorkCenter 150
5,X3
4-9
REP 3.3 Scanner
and
Guide Asselnbly