Table of Contents
Advertisement
System Checks
Initial conditions
Inspect for the following conditions:
.
Ensure the telephone is connected properly.
.
Ensure that the telephone line cable is
connected correctly at the machine line jack
and the wall jack.
-
Ensure that the power cord is connected lo
the wall outlet and to the machine.
*
No documents are loaded and scanner is
free
of foreign particles.
-
The scanner is correctly closed.
*
The paper is loaded correctly in the printer.
*
Ensure the parallel cable is not connected.
Off-Line System Checks
NOTE:
If an ERROR
MESSAGE
appears at any time, do
Refer to section
2, &b/e
1 disg&
LuQSiWLor
tahb 2
elmr -and
NOTE:
The displays
shown in the
system checks may vary fmm those on
the
machine
being
tested
in
/he
following areas:
.
Time
.
Local ID
*
Telephone numbers
*
Original and resolution selections
.
CCITT operation modes (9600, ECM)
Differences in the above items should not be
interpreted as a problem.
1.
2.
3.
4.
5
6
7
Unplug the WorkCenter from the outlet. Wait
10 seconds, then plug the WorkCenter in.
All LEDs light, the self test performs, then
the Standard LED remains lit.
i
kpl0
The display indicates the following:
1 09:llAM
AUTO 1
NOTE: Display may vary if mode is set
to Manual, Fax Tel, or FwTam.
i
LPI3
During the self test the carriage and paper
feed motors run brietly and sound normal.
Y
N
I
Rap 18
Three beeps are heard when the
Copy
key is
pressed.
i
:ap+s
Print an Activity report, press
The report prints and feeds out of the
machine.
i
~ap16
image quality of the print is acceptable.
i
fbRap1
Insert the standard test pattern (82P151) into
the scanner.
Document feeds into the scanner.
i
lap21
6.
9.
10
11
12
13.
14.
Press the Copy key.
The Fine LED is on, The Standard LED is
off and the display indicates the following:
1 Copies : 01
i
:a,21
b]
Press the Start key.
The document feeds through the *canner
and a copy is printed.
indicates the following:
The display
Copying
i
LIP21
Ol/Ol )
The display returns to Standby mode, The
Standard LED is on and the Fine LED is off.
i
:.place
Main PWB (REP 8.1).
tmage quality of the copy is acceptable.
i
!lRsp,
Open the scanner.
A beep is heard, the Error LED lights and
the display indicates the following:
Door Open
i
zap17
Close the scanner.
Go to On-Line System Checks,
System Checks
5/96
1-4
Document WorkCenter 150
Advertisement
Chapters
Table of Contents
