Rep 5.3 Maintenance Station - Xerox Document Workcenter 150 Service Manual

REP 5.3 Maintenance Station
Part
List on PL 5.1
Removal
CAUTION
Leaving the Ink C&ridge removed for long
periods of time wi// cause fhe ink nozzles to
dry out. image quality problems or a blank
print could msulf. If necessary prime the Ink
Cartridge after minstallation.
1. Disconnect the Power Cord from the outlet.
2. Remove the following:
a. Ink Cartridge Cover (PL 3.1).
b. Ink Cartridge.
c. Rear Cover (REP 1.2).
d. Printer and Tray Assembly (REP 3.1).
e. Printer Assembly (REP 3.2).
f. Carriage Assembly (REP 3.5).
3. Remove the Maintenance Station (Figure 1).
a. Place the Carriage Assembly on its side.
b. Push the tab.
c. Remove the Maintenance Station.
Replacement
1. Ensure the four (4) guides and the locking tab
are engaged (Figure 2).
2. Ensure the Maintenance Tube is positioned in
the damp behind the arm (Figure 1).
3. Reinstall the remaining components in the
reverse order.
Adjustments
I. Head Gap (ADJ 5.2)
2. Grid Adjust (ADJ 5.1)
Maintenance Station
Tube
/
Figure 1
Replacing the Maintenance Station
REP 5.3 Maintenance Station
5/96
4.24
Document WorkCenter 150