Section Contents - Xerox Document Workcenter 150 Service Manual

introduction
Overview
The Repair I Adjustment section, Section 4 of the
Service Manual, provides information that enables
the Service Representative to restore the product
to within specification after fault isolation.
Section Contents
The Section Contents lists, in sequence, all the
items of the section, with page references. Each
entry in the section contents appears exactly as it
appears in the manual.
Repair Procedures
This repair subsection contains instructions for
removal and replacement tasks. A removal and/or
replacement task is included when it is not obvious
how components are removed and replaced. or
when special conditions (such as an adjustment)
must be met during these tasks.
Step-by-step removal procedures for a specific
component or assembly are provided.
A good. general procedure to follow for most
repairs is to remove the handset and cradle. Also,
disconnect all the modular cables from the
machine.
Illustrations are used to assist you with the
procedures. You should refer to the specific Parts
List illustration (listed under the repair title) for
locating most components within a procedure.
Adjustment
The adjustment subsection consists of a complete
set of instructions for performing independent
adjustment tasks.
The title of each independent adjustment is in
boldface type. Under the title, the adjustment task
contains the following sections:
Purpose
The Purpose of the adjustment task states the
reason for performing the adjustment.
Gflak
The Check defines the quickest way to determine
whether the adjustments are within specification.
A check is used only when it is possible to
determine that the component is within
specification without disturbing the adjustment.
The Adjustment contains complete instructions for
performing the adjustment task,.
I
6
'S ,
Introduction
5196
4-2
Document WorkCenter 150