Table of Contents
Advertisement
REP 7.1
Pump
Parts
List on PL 7.1
Removal
WARNING
h&mect
the Power Cord from the
1. Remove the following:
c.
Rear Cover (REP 1.2).
d. Printer and Tray Assembly (REP 3.1).
e.
Printer Assembly (REP 3.2).
2.
Remove the Pump (Figure 1).
a.
Disconnect the Pump Tube.
b.
Remove the Pump.
Replacement
1. Ensure that the locating pin on the Pump
mounting surface engages the motor flange
Slot.
2. Ensure that the Pump tube is routed to avoid
restrictions and is connected to the inlet port.
3.
Reinstall the remaining components in the
reverse order.
I "
\
Inlet Port
Puinp Tube
f
I
,9 6
Fig&e 1
Removing the Pump
REP 7.1 Pump
5196
4-34
Document WorkCenter 1x1
Advertisement
Chapters
Table of Contents
