Setting The Menu To Be Shown When The Menus Are Started; Setting The Mouse Wheel Scrolling Direction For Parameter Setting; Selecting The Mouse Button Used For Adjusting The Knob Parameters - Sony MVS-8000X System User Manual

Setting the Menu to be Shown When the Menus Are
Started
1
2
Notes
To enable this setting, the initial state of the control panel when powered on
must be set to one of the following.
• Set to Resume mode
• Set to Custom mode, with "User" selected in the <Setup> group.
For details of these settings, see "Selecting the State After Powering On (Start
Up Menu)" (page 914).
Setting the Mouse Wheel Scrolling Direction for
Parameter Setting
In the < Mouse Wheel Direction > group of the Panel >Maintenance menu,
press one of the following buttons.
Scrl Down = Clockwise: Turning the mouse wheel in the direction to scroll
Scrl Up = Clockwise: Turning the mouse wheel in the direction to scroll up is
Selecting the Mouse Button Used for Adjusting the
Knob Parameters
In the Panel >Maintenance menu, press either of the following buttons in the
<Mouse Sliding Control> group.
Left Button: Dragging the bar while holding down the left mouse button
Right Button: Dragging the bar while holding down the right mouse button
1016
Screen Saver and Other Settings (Maintenance Menu)
In the Panel >Maintenance menu, press [Initial Menu Set].
A popup window appears.
Enter the page number of the desired menu.
The next time the menus are started, the menu specified by this number
appears.
down is the same as turning the parameter setting knob clockwise.
the same as turning the parameter setting knob clockwise.
adjusts the parameter assigned to the knob.
adjusts the parameter assigned to the knob.