Sony MVS-8000X System User Manual page 1081

Aux? O'ride Src??
• When the trigger type is "Level"
(In M/E-x, the x is the M/E bank number (1 to 4)).
System Format, System Aspect, M/E-x Aspect, P/P Aspect, DME Ch1
Aspect, DME Ch2 Aspect, DME Ch3 Aspect, DME Ch4 Aspect, DME
Ch5 Aspect, DME Ch6 Aspect, DME Ch7 Aspect, DME Ch8 Aspect,
Level Enable, No Action
Notes
• "Level Enable" is a function that determines whether GPI inputs are enabled
("Enable") or disabled ("Disable") for the Aspect and Format actions that
can be used when the trigger type is Level. When Level Enable is used, if the
input is "Disable" then it is not possible to switch Aspect or Format by GPI
input.
If a GPI to switch Aspect or Format occurs when powering the system off,
the action triggered by the GPI may start immediately before the power goes
off and the power may go off before the action is completed. This may
corrupt the setup settings. It is therefore recommended to use Level Enable
to avoid such a situation.
• As for "Aux ? O'ride Src ??," when "Rising Edge" is selected, on a rising
edge the set AUX bus input is used. On a falling edge, the original state of
the cross-point is restored. If the GPI trigger is applied repeatedly at short
intervals (0.5 second or less), the cross-point switching may not be carried
out correctly. In this case, apply the GPI trigger again.
• If "SWR Format" or "System Format" is selected for "Action" when the
format converter is used, you can set the conversion formats of the format
converter for "FC Input 1-8" and "FC Input 9-16" "FC Output 1-2" and "FC
Output 3-4".
Carrying out level settings
To set the low level and high level, first set the trigger type to "Level," then use
the following procedure.
1
In the DCU >GPI Input Assign menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
GPI Input Setting (GPI Input Assign Menu)
1081