Setting The Button Operation Mode - Sony MVS-8000X System User Manual

2

Setting the Button Operation Mode

1
2
1008
Operation Settings (Operation Menu)
Make the following settings as required.
When making settings for the Wipe Snapshot menu or DME Wipe
Snapshot menu memory recall buttons: In the <Wipe/DME
Display> group, press to select [Pattern] or [Register Name].
When making settings for the Misc >Snapshot menu memory recall
buttons: In the <Snapshot/Effect Display> group, press to select
[Register No] or [Register Name].
In the Panel >Operation menu, press [Custom Button].
The Custom Button menu appears.
The status area shows a list of the items with their settings.
Make the following settings as required.
Operation mode during an auto transition: For the operation mode
when the [AUTO TRANS] or [TAKE] button is pressed once more
during an auto transition, select [Continue] or [Cancel] in the <Auto
Trans/Take> group.
Continue: Continue the auto transition.
Cancel: Cancel the auto transition and return to the state before
starting the auto transition.
Operation mode during keyframe execution: For the operation mode
when the [RUN] button is pressed once more during effect execution,
select [Continue] or [Cancel] in the <Run> group.
Continue: Continue the execution.
Cancel: Cancel the execution and return to the state before starting the
execution.
Status display for auto transition execution button: When the [AUTO
TRANS] or [TAKE] button is pressed to carry out an auto transition,
select how the button is lit or off in the <Auto Trans/Take Key On
Stats> group.
Disable: Lights amber during the transition, and goes off at the end of
the transition.
Enable: Lights green during the transition, and at the end of the
transition lights red if on air and amber if not on air.
Notes
This setting is only valid in the independent key transition execution
section of the following control block.