Setting the AUX Bus Override Operating Mode
Set the operating mode when the trigger type is "Rising Edge" or "Falling
Edge," and "Aux ? O'ride Src ??" is selected as the GPI input action.
In the <Aux Bus Override Mode> group of the Panel >Device Interface menu,
select one of the following modes.
Momentary: On an input pulse rising (falling) edge, the input of the selected
AUX bus is used, and on a falling (rising) edge this returns to the original
cross-point.
Latch: On an input pulse rising (falling) edge, the input of the selected AUX
bus is used, and this does not return to the original cross-point change even
on a falling (rising) edge.
This setting is also valid when AUX bus override is selected as the DCU GPI
input (see page 1079).
Interfacing With External Devices (Device Interface Menu)
1003