SeaSpace TeraScan 1.5M Operation And Maintenance Manual page 198

10.3 S
OFTWARE
10.3.1 ac
ac chain
182 SeaSpace Corporation
C
OMMANDS AND
az xxx.x
el xxx.x
cl xx.x
eltorque
cltorque
pos
reset
version
head
(n)
st
^0070
^0071
^0000
NVRAM
?
x
O00xy
program FILE_NAME
F
ILES
Move to azimuth xx.x degrees (0-360.0).
Move to elevation xxx.x degrees (0-90.0).
Move to cross-level xx.x degrees.
Note: Cross-level angle must be 72 to 108 degrees.
Test antenna torque on the elevation.
Read motor load from PCU.
Test antenna torque on the cross level beam.
Read motor load from PCU.
Read position of antenna, high precision.
[0.0, 360.0] degrees = [0000, FFFF] counts.
Reset the PCU.
Report PCU Prom version.
Report current ship heading.
Output command n during tracking.
(No wait for the antenna program).
Read antenna status.
Set PCU to Fast Reference mode.
Set PCU to Satellite Reference mode
(Sea-going antenna).
Gyro mode (land-based antenna)
Update PCU NVRAM
List command set for this type of antenna.
Get motor torque for cross level, elevation, and azimuth motors.
O0000 = L-Band feed polarity select.
O0001 = S-Band feed polarity select.
Loads program named FILE_NAME into 6003AL PCU.
Example: program x03-268L.s19
Before running this command, make sure no pass is
scheduled to be tracked for 15 minutes, and make sure the
antenna is not being initialized. After running this comand,
reset the antnna (ac chain reset).