Table of Contents
Advertisement
178 SeaSpace Corporation
^0000
Gyro mode:
^0005
Reset all trim values to 0 (N4000, N5000, N6000)
^0004
Cross-level trim: Tip cross-level beam left by 0.4833
^0006
Cross-level trim: Tip cross-level beam right by 0.4833
^0002
Elevation trim: Tip level cage away from dish by 0.4833
^0008
Elevation trim: Tip level cage toward dish by 0.4833
^0067
Toggle dish scan on/off. Not used.
^0070
Set PCU to Fast Reference mode.
^0071
Satellite Ref Mode: The antenna does not move when the shipheading
^0087
Write PCU NVRAM.
^0090
Reset (initializes) the PCU.
Note: All changes must be followed by an NVRAM write (ac 1 NVRAM).
When the antenna shipheading changes, the antenna
moves to match the change. Use only with sea-going
antenna when tracking a pass. See Section 4.5,
page 81.
Changes N4___.
Changes N4___.
Changes N5___.
Changes N5___.
changes. Used only with sea-going antenna when
antenna is idle.
º.
º.
º.
º
.
Advertisement
Chapters
Table of Contents
