8.5 C
ALIBRATION AND
8.5.1 Balancing the Antenna
Tools:
⁄
" nut driver
7 16
6" crescent wrench
Procedure:
1.
Place the antenna dish at 0º elevation (horizontally). Add or subtract trim weights to the right or left
side of the antenna at the dish or on the counter-balance area of the frame behind the dish until the
cross-level beam is balanced. Use 1-oz or ½-oz weights with ¼-20 cap screws.
2.
Move the dish to 90º elevation. If the dish drifts, redistribute the weights. Note: Do not add new
weights.
3.
Return to Step 1 and recheck the drift at 0º elevation.
4.
When properly balanced, the positioner should not move in any direction when the dish is placed at
any elevation. The cross-level beam should remain level.
F
IGURE
152 SeaSpace Corporation
A
DJUSTMENT
Balancing the Antenna (View of Right Elevation Pan)
8-22:
P
ROCEDURES
Trim Weights