Olivetti d-color MF1600 Service Manual page 157

Display Cause
Service call Defective fuse
150: Error cutting of ID unit
153: Error
Service call Defective fuse
154: Error cutting of belt
unit
Service call Defective fuse
155: Error cutting of fuser
Service call Defective toner
160: Error sensor detection.
It does not occur
163: Error during shipping
setting
Service call Thermistor
167: Error Slope Error
Service call Compensation.
168: Error Thermistor Error
Service call Upper Side
169: Error Thermistor Error
Service call Thermistor Short
170: Error circuit / Open
171: Error circuit of the
fuser is detected
Service call Thermistor
172: Error Temperature
173: Error abnormality (high
or low) of the
fuser is detected Does the error recur?
Y108500-4
Table 7-1-2 service call error list (3/6)
Details of error
Is the ID unit installed correctly?
Does the error reoacur?
Does it restore by exchanging
PRE board
Is the belt unit installed correctly?
Does the error recur?
Is the fuser installed correctly?
Does the error recur?
Is the toner cartridge installed?
Is the lock level of toner set?
Does the error recur?
Does the error recur?
Does the error recur?
Is the error message displayed?
Does the error recur?
Is the error message displayed?
Does the error recur?
Is the error message displayed?
Does the error recur?
Does the error recur?
Service Manual
Method
No Installed ID unit again
Yes Turn on the power supply again
Yes Replace PRE board after check
the cable connection of PRE
board-M32 board.
Replace M32 board.
No Reinstall the belt unit.
Turn on the power supply again.
Yes Replace M32 board after check
Yes cable connection.
No Reinstall the fuser after its
connection connector is cleaned
Yes Turn on the power supply again
Yes Replace M32 board after check
the cable connection.
No Install a toner cartridge.
No Turn the lock lever of toner
cartridge to the fixed position.
Yes Remove the right side cover, take
measures to prevent the right side
of the device from being exposed
to ambient light, and confirm that
the toner sensor is lighted during
initialization of the device.
Yes Reconfirm it after replacing the
toner sensor Assy.
Yes Replace the M32 board.
Yes Turn on the power supply again
Yes Turn on the power supply again
after storage for 30 minutes.
Yes Turn on the power supply again
Yes Turn on the power supply again
after storage for 30 minutes. Note)
Yes Turn on the power supply again
Yes Turn on the power supply again
after storage for 30 minutes.
Check the cable connection
between the ZAK board and M32
board and turn on the power
again.
Yes Replace the fuser unit.
Replace the M32 board.
See Note.
Check the cable connection
between the ZAK board and M32
board and turn on the power
again.
Yes Replace the fuser unit.
Replace the M32 board.
157