Olivetti d-color MF1600 Service Manual page 155

(2) Service Call Error
The service call error list is recording in table 7-1-2.
Display Cause
Service call CPU Excepption
002: Error
005: Error
Service call CU RAM
030: Error Check Error
Service call CU Optical RAM
031: Error Check Error
Service call CU EEPROM
040: Error Error
Service call CU Flash Error
041:Error Flash ROM Error
on the CU board
Service call Flash File
042: Error System Error
043: Error
Service call Engine I/F Error
072: Error I/F Error
between PU and
CU
Service call Video Error
073: Error When the image
data sprads,
defect is
detected.
(Incorrect data
receive)
Service call Video Error
074: Error When the image
075: Error data spreads,
defect is
detected.
Service call Difference
081: Error between version
of CU firm and
EEPROM
Y108500-4
Table 7-1-2 service call error list (1/6)
Details of error
Is the error message displayed
again?
Is the error message displayed
again?
Is RAM DIMM mounted normally?
Does it restore by exchanging RAM
DIMM?
Is the error message displayed
again?
Is the error message displayed
again?
It failed to the access to CU Flash
ROM that is attached to the BLA
board directly.
Does the error recur?
Does the error recur?
Service Manual
Method
If the RAM DIMM is mounted,
remove it and turn the power
supply off/ON.
Yes Replace M32 board
No Remount RAM DIMM
Replace RAMDIMM
Power supply OFF/ON
Yes Replace M32 board
No Remount RAM DIMM
Yes Replace RAMDIMM
No Replace M32 board
Power supply OFF/ON
Yes Replace M32 board
Power supply OFF/ON
Yes Replace M32 board
The compulsive initialization of
Flash is done. (Because NIC-F/W
is deleted, please be careful to it.
After initialization, it is necessary to
write NIC-F/W by the maintenance
utility).FLASH FORMAT is
executed by using the maintenance
utility.If the symptom doesn't
change, replace the M32 board.
Replace M32 board
Change the PC to high spec or
lower the resolution, and then
print again.
Yes Replace M32 board
Replace M32 board
Do EEPROM Initialization.
(Turn on the power supply by
Cover-open & pressing
key
& pressing CANCEL switch).
Because the Mac address will
disappear with this initialization,
lease reset Mac address by using
the maintenance utility.
Yes
Replace M32 board
START
155