Pppoe Setup; Pppoe Overview; Pppoe Settings; Send Mail After Ppoe Dialed - Wirepath Surveillance WPS-750-DOM-IPH Installation Manual

WPS-750-DOM-IPH Installation Manual

10.3.6. PPPoE Setup

10.3.6.1. PPPoE Overview

Point-to-Point Protocol Over Ethernet (PPPoE) is a network protocol primarily used with DSL (Digital Subscriber Line) providers and
modems. This protocol requires a login to connect to the modem even when a router is used. Configuration of these settings is not
required to operate the camera on a standard network.
• Navigation: Log in as an administrator. From Home Screen, click "Config" button in top right corner, then click "PPPoE &
DDNS" in left column menu.

10.3.6.2. PPPoE Settings

Enabled/
1
Turn PPPoE features on or off. Enable to use PPPoE to access the camera.
Disabled
Username Enter the login name provided by the Internet Service Provider (ISP).
Password
Enter the password provided by the Internet Service Provider (ISP).
Click "Apply" at the bottom right of the page to save modified settings.

10.3.6.3. Send Mail after PPoE Dialed

Enabled Click Enable to send an email when the PPPoE is dialed.
2
Subject Enter a subject line to be used for outgoing emails.
Click "Apply" at the bottom right of the page to save modified settings.
38
1
2