I/O Settings - Wirepath Surveillance WPS-750-DOM-IPH Installation Manual

10.5.4. I/O Settings

10.5.4.1. Input Settings
1
DI Sensor
State
Send To
Subject
Interval
Only at
Schedule
Times
Click "Apply" at the bottom right of the I/O Settings page to save modified settings.
10.5.4.2. Output Settings
2
Mode Setting
Interval
Click "Apply" at the bottom right of the I/O Settings page to save modified settings.
© 2014 Wirepath Surveillance
1
2
N.O Camera expects contact closure connected to the DI input to be normally Open. Event is triggered
when the contact is closed.
N.C Camera expects contact closure connected to the DI input to be normally Closed. Event is
triggered when the contact is open.
If notification or logging is desired, select the destination to send it to when the DI input event is
triggered.
Enter a name to use to identify the event.
Select the time to wait between input events before another event can be triggered.
When selected, events will only be monitored based on a configured schedule. Scheduling must be
enabled for this feature to work.
Open/Close Manually Device connected to the DO output can be triggered from the browser GUI or
configured Events only.
Open/Close at Interval DO output will be cycled between Open and Closed at the Interval configured
below.
Select the interval between DO output Open and Close when Mode Setting is "Open/Close at Interval".
WPS-750-DOM-IPH Installation Manual
61