Administrator Account Setup; Add, Edit, Or Remove A Guest Account - Wirepath Surveillance WPS-750-DOM-IPH Installation Manual

10.2.3.5. Administrator Account Setup

Once the camera is accessible on the network, the administrator password should be changed to prevent unwanted access. Select
a new password up to ten characters in length made up of letters and numbers (no punctuation or symbols).
A. Click the "Edit" button next to the username "admin" in the User List to open the User Setup window.
B. Change the Administrator username and enter a new password, or re-enter the existing password in each password field, then
click "OK" to save the changes.
C. After selecting OK, the camera will automatically log out. Enter the new log-in information in the pop-up and sign back into the
camera as normal to continue setup. Be sure to record the Administrator account information in a safe place. If administrator
account access is lost, a manual reset of the camera is required.

10.2.3.6. Add, Edit, or Remove a Guest Account

To create a new Guest account, enter the desired username and password in the fields as indicated on the previous page in section
10.2.3.2. Add User (Guest Account
After a Guest account has been created, the password may be changed by clicking the "Edit" button in the User List. To change the
username, a new account must be created and the old one removed.
© 2014 Wirepath Surveillance
only), and then click the "Add" button to add the new user.
WPS-750-DOM-IPH Installation Manual
25