Camera A/V Settings; Image Settings Menu - Wirepath Surveillance WPS-750-DOM-IPH Installation Manual

WPS-750-DOM-IPH Installation Manual

10.4. Camera A/V Settings

10.4.1. Image Settings Menu

The image setting menu is used to set up the camera view for the best image possible. Brief descriptions of the menu are given
below. Complete instructions for setup are in the following sections.
• Navigation: Log in as an administrator. From Home Screen, click "Config" button in top right corner, then click "Image
Settings" in the left column menu.
1
Privacy Mask See section
Image Setting
2
Brightness Adjust overall brightness from -4 (Low) to +4 (High). Default: zero (0).
Contrast Adjust white levels from -4 (Low) to +4 (High). Default: zero (0).
Hue Adjust the color tone (or tint) between -4 (Blue) and +4 (Red). Default: zero (0).
Saturation Adjust color intensity from -4 (Low) to +4 (High). Default: zero (0).
Sharpness
Adjust edge detail from -4 (Low) to +4 (High). Default: zero (0).
AGC Auto Gain Control balances high contrast scenes. Adjust from 16x (Low) to 64x (High). Default: 16x.
Shutter Time Use automatic Indoor or Outdoor preset modes or set 1/30(Slow)-1/1000 (Fast). Default: Outdoor.
Sense-Up Set slow shutter time for use in low light areas from 1/5 (Slow) to 1/30 (Fast). Default: 1/15.
Digital Wide Dynamic Range balances dark and bright areas in low light scenes to maintain high image
D-WDR
quality. Turn on and set from 1 (Low) to 8 (High). Default: Off.
Anti-Fog Check Enable to clear foggy scenes using software, Default: Off.
Lens
Adjust the image so that curvature image distortion caused by the lens is reduced to a minimum. Turn
Distortion
on and set from 1 (Low) to 8 (High). Default: Off.
Correction
Lens
Check the box for Flip or Mirror to change the image appearance. Both settings are disabled by default.
Orientation
Red/Blue Gain Set the red and blue balance from -5 (Low) to 5 (High). Default: 0.
3D - Reduces noise around moving objects. Default: 5.
Digital Noise
Reduction
2D - Reduces noise around stationary objects. Default: 1.
Default Click to reset all Image Setting menu values.
Day & Night
3
See section
Setting
44
1
2
3
10.4.2.5. How to Configure Privacy Masks
10.4.2. How to Configure Day & Night Settings (Color Modes)