Table of Contents
Advertisement
WPS-750-DOM-IPH Installation Manual
6. Camera Connections
Wirepath™ Surveillance IP Cameras can be powered by Power over Ethernet (PoE) through the Cat5e/Cat6 Ethernet connection.
This method is recommended because it limits the amount of wiring required, reducing installation cost and time. The camera must
be connected to a compatible PoE-equipped router/switch or a PoE injector for this method to work.
7.
Ethernet Connection (RJ45)
Connect to network switch for communication to and from the camera. Pin out follows EIA standard 568-B.
8.
12V DC Power In (Barrel Connector)
Connect to a 12V DC power supply. The camera is not supplied with a power supply. No power supply is needed if PoE is
being used to power the camera via the Ethernet connection.
Warning! Use only a 12V DC power supply with this camera. Higher voltages or AC current will cause permanent damage
that is not covered by the warranty.
9.
Audio In (1/8" / 3.5mm Stereo)
Connect a microphone to receive audio at the cameras location.
10. Audio Out (1/8" / 3.5mm Stereo)
Connect to an amplifier and speakers to allow for communication between the viewer and the cameras location.
11. Contact & Relay (Spring Loaded Terminal)
Connect to devices with contact closure output to trigger recording, or activate devices like lights or sirens at the camera
location.
10
1. Ethernet
2. 12V DC In
(Black)
T
R
S
T
R
S
DO
GND (Ground) Common (-)
DI
DO — Max +5V DC 50mA
3. Audio In
(Pink)
T
(Tip)
Positive (+)
R
(Ring)
NOT USED
S (Sleeve)
Common (-)
T
(Tip)
Positive (+)
R
(Ring)
NOT USED
S (Sleeve)
Common (-)
(Output)
Switched
(Input)
Contact
5. Contact
& Relay
Hide quick links:
Advertisement
Table of Contents
