Table of Contents
Advertisement
10.3.4. Advanced IP Settings - Access List (IP Filter)
IP address filtering is used to allow or deny access to the camera from individual IP addresses or ranges of IP addresses. This adds
an additional layer of security to the camera.
To ensure that the camera can be accessed by the Admin after setting up the list, the IP address of the
administrator's PC must be enabled in the list. Or, if it is within a range of disabled addresses, select the
"Allow Admin IP Always" check box and enter the address of the Admin PC.
•
Navigation: Log in as an administrator. From Home Screen, click "Config" button in top right corner, then click "Advanced" in
left column, then click "Access List" from the sub-menu that opens.
10.3.4.1. IP Address Filter Setting
1
Enable
IP Address
Access List
Allow Admin
IP Address...
Admin IP
Address
Click "Apply" at the bottom right of the page to save Administrator IP Address access settings.
© 2014 Wirepath Surveillance
1
Check the box to enable IP address filtering for all visitors.
Use this area to add IP addresses to the list for access or denial. Filtering must be enabled. See next
section,
10.3.4.2. Add or Remove IP Addresses or Ranges
Displays the IP addresses currently allowed or denied access to the camera. Click "Remove" in the
Action column on the right to delete an entry.
Check the box to restrict Administrator access to only one address. (LAN or WAN address). See section
10.3.4.3. Controlling Administrator Access
Enter the address the Administrator will access the camera from.
WPS-750-DOM-IPH Installation Manual
for instructions.
for instructions.
35
Hide quick links:
Advertisement
Table of Contents
