Pppoe Setup; Pppoe Overview; Pppoe Settings; Send Mail After Pppoe Dialed - Wirepath Surveillance WPS-300-BUL-IP Installation Manual

9.3.6. PPPoE Setup

9.3.6.1.

PPPoE Overview

Point-to-Point Protocol Over Ethernet (PPPoE) is a network protocol primarily used with DSL (Digital Subscriber Line) providers and
modems. This protocol requires a login to connect to the modem even when a router is used. Configuration of these settings is not
required to operate the camera on a standard network.
• Navigation: Log in as an administrator. From Home Screen, click "Config" button in top right corner, then click "PPPoE &
DDNS" in left column menu.
9.3.6.2.

PPPoE Settings

Enabled/
1
Disabled
Username
Password
Click "Apply" at the bottom-right of the page to save modified settings.
9.3.6.3.

Send Mail after PPPoE Dialed

Enabled
2
Subject
Click "Apply" at the bottom-right of the page to save modified settings.
© 2014 Wirepath Surveillance
1
2
Turn PPPoE features on or off. Enable to use PPPoE to access the camera.
Enter the login name provided by the Internet Service Provider (ISP).
Enter the password provided by the Internet Service Provider (ISP).
Click Enable to send an email when the PPPoE is dialed.
Enter a subject line to be used for outgoing emails.
WPS-300-BUL-IP Installation Manual
35