Table of Contents
Advertisement
Front Panel Connectors
HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET SW - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-BTN - Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1
(POS - Power On Suspend) state, it will blink every second. When the system is in
the S3 (STR - Suspend To RAM) state, it will blink every 4 seconds.
Note: If the system did not boot-up and the Power/Standby LED did not light
after it was powered-on, it may indicate that the CPU or memory module was
not installed properly. Please make sure they are properly inserted into their
corresponding socket
Pin
N. C.
1
HDD-LED
3
5
RESET SW
7
9
N. C.
11
MBATX-945G-VGA User's Guide
.
Pin Assignment
N. C.
PWR-LED
HDD Power
PWR-BTN
Signal
Ground
RST Signal
N. C.
Key
Pin
Pin Assignment
2
LED Power
4
LED Power
6
Signal
8
Ground
10
Signal
12
Key
page 61
Advertisement
Table of Contents
