Table of Contents
Advertisement
HDD Power Down
This is selectable only when the Power Management field is set to User Define. When
the system enters the HDD Power Down mode according to the power saving time
selected, the hard disk drive will be powered down while all other devices remain active.
Soft-Off by PWR-BTTN
This field allows you to select the method of powering off your system.
Delay 4 Sec. Regardless of whether the Power Management function is enabled
Instant-Off
PWR Lost Resume State
Keep Off
When power returns after an AC power failure, the system's power is
off. You must press the Power button to power-on the system.
Turn On
When power returns after an AC power failure, the system will
automatically power-on.
Last State
When power returns after an AC power failure, the system will return
to the state where you left off before power failure occurs. If the
system's power is off when AC power failure occurs, it will remain off
when power returns. If the system's power is on when AC power
failure occurs, the system will power on when power returns.
Wake-Up By PCI Card
Enabled
This field should be set to Enabled only if your PCI card such as LAN
card or modem card uses the PCI PME (Power Management Event)
signal to remotely wake up the system. Access to the LAN card or PCI
card will cause the system to wake up. Refer to the card's
documentation for more information.
Disabled
The system will not wake up despite access to the PCI card.
MBATX-945G-VGA User's Guide
or disabled, if the power button is pushed and released in less than 4
sec, the system enters the Suspend mode. The purpose of this
function is to prevent the system from powering off in case you
accidentally "hit" or pushed the power button. Push and release
again in less than 4 sec to restore. Pushing the power button for
more than 4 seconds will power off the system.
Pressing and then releasing the power button at once will
immediately power off your system.
page 89
Advertisement
Table of Contents
